LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 6L80/6L90 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P2723 or P2724 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
    NOTE:

    If other DTCs are set, diagnose those DTCs first.

  1. Engine idling in Park position, with parking brake applied and drive wheels chocked.
  2. Verify the transmission fluid level and condition is correct. Refer to Transmission Fluid Level and Condition Check .
    • If the transmission fluid level and condition is not correct 

      Repair as necessary.

    • If the transmission fluid level and condition is correct 
  3. Ignition ON, clear the Transmission Control Module DTCs with a scan tool.
  4. Verify the transmission operation performs as indicated in the road test instructions and DTCs P2723 or P2724 did not set. Refer to Road Test .
    • If DTCs P2723 or P2724 did not set 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observe from the Freeze Frame/Failure Records data.
  6. Verify the DTC does not set.
    • If the DTC does not set 
  7. All OK.
scientia non olet · About LEMON Manuals