Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P182E
The IMS does not indicate a valid Park, Reverse, Neutral or Drive Range gear position for 7 seconds.
P1915
The manual shift shaft IMS switch assembly does not indicate Park or Neutral during the following sequence:
- The engine speed is less than 50 RPM for more than 1 second.
- The engine speed is 50-480 RPM for more than 1 second.
- The engine speed is greater than 525 RPM for more than 2 seconds.
- The transmission input shaft speed is 200 RPM or greater.