Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.

NOTE:

You must perform the Circuit/System Verification first.

Ignition OFF, remove the Q8 Control Solenoid Valve Assembly.
Verify the Q8 Control Solenoid Valve Assembly is not contaminated with any debris. Refer to Control Solenoid Valve and Transmission Control Module Assembly Inspection .
- If contaminated
  Clean as necessary.
- If not contaminated
Verify the resistance is within the specified range for each solenoid. Refer to Control Solenoid Valve and Transmission Control Module Assembly Inspection .
- If resistance is not within range
  Replace the Q8 Control Solenoid Valve Assembly.
- If resistance is within range
Place the Q8 Control Solenoid Valve Assembly on a clean work surface near the transmission assembly.
Connect DT-47825-10 jumper harness between the vehicle wire harness electrical connector and the Q8 Control Solenoid Valve Assembly electrical connector. Ignition ON.
Verify the scan tool the parameters listed below do not display Malfunction:
- Line Pressure Control Solenoid Valve Performance Test Status
- Line Pressure Control Solenoid Valve Control Circuit High Voltage Test Status
- Line Pressure Control Solenoid Valve Control Circuit Low Voltage Test Status
- If Malfunction is displayed
  Replace the Q8 Control Solenoid Valve Assembly.
- If Malfunction is not displayed
All OK.