LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 6L80/6L90 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0872 or P0873 >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different variant/trim than selected.

The Transmission Fluid Pressure Switch 3 is part of the control solenoid valve assembly which has no serviceable parts. The Transmission Control Module supplies a signal circuit to the Transmission Fluid Pressure Switch 3. The Transmission Fluid Pressure Switch 3 has an internal case ground. Transmission Fluid Pressure Switch 3 is normally closed or LOW. When oil pressure is present at the Transmission Fluid Pressure Switch 3, the switch is open or HIGH. The normally low clutch pressure control (PC) solenoid 4 controls pressure to the 2-6 clutch regulator valve. The Transmission Control Module monitors the Transmission Fluid Pressure Switch 3 to determine the position of the 2-6 clutch regulator valve. When the 2-6 clutch is commanded OFF, pressure is present on the Transmission Fluid Pressure Switch 3. When the 2-6 clutch is commanded ON, the 2-6 clutch regulator valve moves and pressure is exhausted through the 2-6 clutch regulator valve.

scientia non olet · About LEMON Manuals