LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 6L80/6L90 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0842 or P0843 >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different variant/trim than selected.

P0842 

The Transmission Control Module detects that the Transmission Fluid Pressure Switch 1 signal voltage remains LOW after the 3-5-R clutch transitions from a HIGH pressure state to a LOW pressure state. The Transmission Control Module counts each incident. The DTC sets when 25 counts are accumulated.

P0843 

The Transmission Control Module detects that the Transmission Fluid Pressure Switch 1 signal voltage remains HIGH after the 3-5-R clutch transitions from a LOW pressure state to a HIGH pressure state. The Transmission Control Module counts each incident. The DTC sets when 24 counts are accumulated.

scientia non olet · About LEMON Manuals