Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P0815 - Condition 1
The BCM detects a stuck ON Tap Up switch for 1 second in Park or Neutral.
P0815 - Condition 2
The BCM detects a stuck ON Tap Up switch for 10 minutes in any forward gear.
P0816 - Condition 1
The BCM detects a stuck ON Tap Down switch for 1 second in Park or Neutral.
P0816 - Condition 2
The BCM detects a stuck ON Tap Down switch for 10 minutes in any forward gear.
P0826
The BCM detects an invalid voltage on the TAP up/down signal circuit for 1 minute.
P1876
The BCM detects a TAP Enable Switch request 3 times when not in M (D6) range for 2 seconds.