Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0401, P042E, P0716, P0717, P0722, P0723, or P182E is not set.
Ignition voltage is between 8.6-32 V.
The engine speed is between 400-7,500 RPM for 5 s.
The internal mode switch range is not PARK, NEUTRAL or REVERSE.
High Side Driver is enabled.
The transmission fluid temperature is -6.6°C (20.12°F).
Accelerator pedal position signal is valid.
The throttle position signal is valid.
The output shaft speed is 0 RPM or greater.
The TCM must receive a valid torque signal from the ECM.