Conditions for Running the DTC

P0741

• DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0401, P042E, P0716, P0717, P0722, P0723, P0742, P2763, or P2764 is not set.
• Ignition voltage is between 8.6-32 V.
• The engine speed is between 400-7,500 RPM for 5 s.
• The transmission fluid temperature is -6.6 to +130°C (+20 to +266°F).
• The accelerator pedal position signal is valid.
• The throttle position is greater than 8 percent.
• The TCM must receive a valid torque signal from the ECM.
• The engine torque is greater than 50 N.m (36 lb ft).
• The TCC is commanded ON and PWM duty cycle is greater than 60 percent for 5 s.
• The gear ratios listed below should be in range when the specific gear while the TCC is On:
  • The 2nd gear ratio is between 2.20-2.53.
  • The 3rd gear ratio is between 1.44-1.65.
  • The 4th gear ratio is between 1.07-1.23.
  • The 5th gear is between 0.79-0.91.
  • The 6th gear is between 0.62-0.72.

P0742

• DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0401, P042E, P0716, P0717, P0722, P0723, P0741, P2763, or P2764 is not set.
• DTC P0742 has not passed this key ON.
• Ignition voltage is between 8.6-32 V.
• The engine speed is 400-7,500 RPM for 5 s.
• The transmission fluid temperature is -6.6 to +130°C (+20 to +266°F).
• The accelerator pedal position signal is valid.
• The throttle position is greater than 8 percent.
• The TCM must receive a valid torque signal from the ECM.
• The engine torque is greater than 115 N.m (85 lb ft).
• The vehicle speed is greater than 16 km/h (10 mph).
• The gear ratio is between 0.62-1.63.
• The commanded gear is 2nd.
• The TCC is commanded OFF.