Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0711
- DTCs: P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0401, P042E, P0658, P0668, P0669, P06AD, P06AE, P0716, P0712, P0713, P0717, P0722, P0723, P0962, P0963, P0966, P0967, P0970, P0971, P215C, P2720, P2721, P2729, or P2730 is not set.
- Ignition voltage is between 8.6-32 V.
- The engine speed is 400-7,500 RPM or greater for 5 s.
- The vehicle speed is 8 km/h (5 mph) or greater for 5 min.
- The accelerator pedal position signal is valid.
- The engine torque signal is valid.
P0712
- DTC P0712, P0716, P0717, P0722, or P0723 is not set.
- The engine speed is greater than 400-7,500 RPM for 5 s.
- Ignition voltage is between 8.6-32 V.
P0713
- DTC P0713, P0716, P0717, P0722, or P0723 is not set.
- The engine speed is greater than 400-7,500 RPM for 5 s.
- Ignition voltage is between 8.6-32 V.