LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 6L80/6L90 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0601, P0603, P0604, or P062F >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF for one minute. Ignition ON.
  2. Verify with a scan tool that DTC P0601, P0603, P0604, or P062F is not set.
    • If any of the DTCs set 

      Replace the Q8 Control Solenoid Valve Assembly.

    • If none of the DTCs set 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observe from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Replace the Q8 Control Solenoid Valve Assembly

    • If the DTC does not set 
  5. All OK.
scientia non olet · About LEMON Manuals