LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Knock Sensor 2 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Wiring Harness Electrical Connector & Components
    GM1698087Courtesy of GENERAL MOTORS COMPANY
  1. Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the engine wiring harness electrical connector (2) from knock sensor.
    3. Fig 2: Right Side Knock Sensor & Bolt
    GM1402140Courtesy of GENERAL MOTORS COMPANY
  3. Remove the knock sensor bolt (739) and knock sensor (718).
scientia non olet · About LEMON Manuals