LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Heated Oxygen Sensor Replacement - Bank 2 Sensor 2 (2500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION:

Refer to Heated Oxygen and Oxygen Sensor Caution .

    Fig 1: View Of Engine Wiring Harness Electrical Connectors, (CPA) Retainers & Engine Harness Clip
    GM1704011Courtesy of GENERAL MOTORS COMPANY
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the connector position assurance (CPA) retainer (3).
  3. Disconnect the engine wiring harness electrical connector (2) from the HO2S electrical connector.
  4. Remove the HO2S electrical connector clip from the engine harness clip (4).
    5. Fig 2: View Of Catalytic Converter Assembly HO2S's
    GM1704012Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Excessive Force and Oxygen Sensor Caution .

  5. Remove the HO2S (3).
scientia non olet · About LEMON Manuals