LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission System Hose/Pipe Replacement (2500 LWB - 98.4L (26 gal) Tank-Front) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT:

Clean all fuel and evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the lines in order to avoid possible fuel and/or EVAP system contamination.

    Fig 1: View Of Fuel Tank Shield & Retainers
    GM1705654Courtesy of GENERAL MOTORS COMPANY
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (2500 LWB - 98.4L (26 gal) Tank Front) .
  2. Remove the fuel tank shield retainers (1) and shield (2).
    3. Fig 2: View Of Fuel Tank Clips
    GM1705656Courtesy of GENERAL MOTORS COMPANY
  3. Remove the EVAP line from the fuel tank clip (1).
  4. Open the fuel tank clips (2-7) and remove the fuel/EVAP lines from the clips.
  5. Disconnect the fuel/EVAP line quick connect fittings from the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 3: View Of Fuel Tank EVAP Lines
    GM1705659Courtesy of GENERAL MOTORS COMPANY
  6. Remove the fuel/EVAP lines from the fuel tank.
scientia non olet · About LEMON Manuals