LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Line Replacement - Canister to Tank (2500 LWB - 43.5L (11.5 gal) Tank-Rear) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT:

Clean the evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the fittings in order to avoid possible EVAP system contamination.

    Fig 1: View Of EVAP Line Clips
    GM1705753Courtesy of GENERAL MOTORS COMPANY
  1. Remove the rear fuel tank. Refer to Fuel Tank Replacement (2500 LWB - 4.35L (11.5 gal) Tank Rear) .
  2. Remove the EVAP line from the clip (1) on the fuel tank.
  3. Open the EVAP line clip (2) and remove the EVAP line from the clip.
  4. Remove the EVAP lines from the clip (3).
  5. Disconnect the EVAP line quick connect fittings from the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 2: View Of Fuel Tank EVAP Lines
    GM1705754Courtesy of GENERAL MOTORS COMPANY
  6. Remove the EVAP lines from the fuel tank.
scientia non olet · About LEMON Manuals