LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Line Replacement - Canister to Tank (2500 LWB - 43.5L (11.5 gal) Tank-Rear) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Tank EVAP Lines
    GM1705754Courtesy of GENERAL MOTORS COMPANY
  1. Install the EVAP lines to the fuel tank.
    2. Fig 2: View Of EVAP Line Clips
    GM1705753Courtesy of GENERAL MOTORS COMPANY
  2. Connect the EVAP line quick connect fittings to the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Install the EVAP lines to the clip (3).
  4. Install the EVAP line to the clip (2) and close the clip.
  5. Install the EVAP line to the clip (1) on the fuel tank.
  6. Install the rear fuel tank. Refer to Fuel Tank Replacement (2500 LWB - 4.35L (11.5 gal) Tank Rear) .
scientia non olet · About LEMON Manuals