LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Line Replacement - Canister to Tank (1500 LWB - 98.4L (26 gal) Tank w/E85) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Tank EVAP Lines
    GM1704932Courtesy of GENERAL MOTORS COMPANY
  1. Install the EVAP lines from the fuel tank.
    2. Fig 2: View Of Fuel Tank Clips
    GM1704930Courtesy of GENERAL MOTORS COMPANY
  2. Connect the EVAP line quick connect fittings at the fuel tank module and vent valves. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Install the EVAP lines to the fuel tank clips (1, 3, 4, and 5) and close the clips.
  4. Install the EVAP lines to the fuel tank clips (2, and 6).
    5. Fig 3: View Of Fuel Tank Shields & Retainers
    GM1704928Courtesy of GENERAL MOTORS COMPANY
  5. Install the fuel tank shields (1, and 4) and retainers (2, and 3).
  6. Install the fuel tank. Refer to Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank + E85) , Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank)  or Fuel Tank Replacement (2500 LWB - 98.4L (26 gal) Tank Front) .
scientia non olet · About LEMON Manuals