LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement (2500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister Vent Solenoid Retainer
    GM1706538Courtesy of GENERAL MOTORS COMPANY
  1. Install the EVAP canister vent solenoid.
  2. Slide the EVAP canister vent solenoid onto the bracket until the retainer (1) engages the clip.
  3. Connect the EVAP canister vent solenoid line quick connect fitting to the vent solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
    4. Fig 2: View Of EVAP CVS Electrical Connector & CVS Bracket
    GM1224403Courtesy of GENERAL MOTORS COMPANY
  4. Connect the chassis wiring harness electrical connector (1) to the EVAP canister vent solenoid.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals