Removal Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE:

Clean all evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting, in order to avoid possible EVAP system contamination.

Fig 1: View Of Fuel Tank EVAP Lines & Canister

Courtesy of GENERAL MOTORS COMPANY

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the EVAP canister bracket bolts and lower the EVAP canister.
Disconnect the fuel tank EVAP line quick connect fittings (1) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .

Fig 2: View Of Quick Connect Fittings

Courtesy of GENERAL MOTORS COMPANY

Disconnect the EVAP canister vent solenoid quick connecting fitting (1) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .

Fig 3: View Of EVAP Canister, Bracket & Bolts

Courtesy of GENERAL MOTORS COMPANY

Remove the EVAP canister.
If necessary, remove the EVAP canister to bracket bolt.
If necessary, remove the EVAP canister from the bracket.