LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Replacement (1500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister, Bracket & Bolts
    GM1706540Courtesy of GENERAL MOTORS COMPANY
  1. If necessary, install the EVAP canister to the bracket.
    2. CAUTION:

    Refer to Fastener Caution .

  2. If necessary, install the EVAP canister to bracket bolt.

    Tighten 

    Tighten the bolt to 25 N.m (18 lb ft).

  3. Position the EVAP canister.
    4. Fig 2: View Of Quick Connect Fittings
    GM1706533Courtesy of GENERAL MOTORS COMPANY
  4. Connect the EVAP canister vent solenoid quick connecting fitting (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: View Of Fuel Tank EVAP Lines & Canister
    GM1704492Courtesy of GENERAL MOTORS COMPANY
  5. Connect the fuel tank EVAP line quick connect fittings (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Install the EVAP canister bracket bolts.

    Tighten 

    Tighten the bolts to 25 N.m (18 lb ft).

  7. Lower the vehicle.
scientia non olet · About LEMON Manuals