LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Cooling System) >> Repair Instructions >> Radiator Surge Tank Outlet Hose/Pipe Replacement (4.8L, 5.3L, and 6.0L Engines) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Air Cleaner Outlet Duct
    GM832066Courtesy of GENERAL MOTORS COMPANY
  1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill) .
  2. Loosen the air cleaner outlet duct clamps at the following locations:
    • Throttle body
    • Mass airflow/intake air temperature (MAF/IAT) sensor
  3. Remove the air cleaner outlet duct.
    4. Fig 2: View Of Surge Tank/Heater Outlet Hose To Mounting Clip (W/O RPO C36)
    GM659127Courtesy of GENERAL MOTORS COMPANY
  4. If equipped without regular production option (RPO) C36 auxiliary heater, remove the surge tank/heater outlet hose (1) from the mounting clip.
    5. Fig 3: View Of Surge Tank/Heater Outlet Hose To Mounting Clip (W/ RPO C36)
    GM688023Courtesy of GENERAL MOTORS COMPANY
  5. If equipped with RPO C36 auxiliary heater, remove the surge tank/heater outlet hose (1) from the mounting clip.
    6. Fig 4: Identifying Heater Hose To Heater Core Fittings
    GM362171Courtesy of GENERAL MOTORS COMPANY
  6. Install the J 43181  heater line quick connect release tool to the surge tank outlet hose (black connector).
  7. Close the J 43181  heater line quick connect release tool around the surge tank outlet hose.
  8. Firmly pull the J 43181  heater line quick connect release tool into the quick connect end of the outlet hose.
    9. Fig 5: View Of Outlet Hose To Heater & Blower Module (W/O RPO C36)
    GM687495Courtesy of GENERAL MOTORS COMPANY
  9. If equipped without RPO C36 auxiliary heater, firmly grasp the outlet hose. Pull the outlet hose in order to disengage the hose from the heater and blower module.
    10. Fig 6: View Of Outlet Hose To Heater & Blower Module (W/ RPO C36)
    GM687496Courtesy of GENERAL MOTORS COMPANY
  10. If equipped with RPO C36 auxiliary heater, firmly grasp the outlet hose. Pull the outlet hose in order to disengage the hose from the heater and blower module.
    11. Fig 7: View Of Surge Tank Outlet Hose & Surge Tank
    GM659059Courtesy of GENERAL MOTORS COMPANY
  11. Reposition the surge tank outlet hose clamp at the surge tank.
  12. Remove the surge tank outlet hose (2) from the surge tank.
    13. Fig 8: View Of Surge Tank Outlet Hose To Water Pump
    GM659180Courtesy of GENERAL MOTORS COMPANY
  13. Reposition the surge tank outlet hose clamp at the water pump.
  14. Remove the surge tank outlet hose from the water pump.
  15. Remove the surge tank outlet hose.
scientia non olet · About LEMON Manuals