LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Cooling System) >> Repair Instructions >> Engine Coolant Thermostat Housing Replacement (LFA, LH6, LMG, LY2, LY5, LY6) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Radiator Outlet Hose
    GM1699336Courtesy of GENERAL MOTORS COMPANY
  1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill) .
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  3. Reposition the radiator outlet hose clamp at the water pump inlet.
  4. Remove the radiator outlet hose from the water pump inlet.
    5. Fig 2: View Of Water Pump Inlet Seal
    GM1702083Courtesy of GENERAL MOTORS COMPANY
  5. Remove the water pump inlet bolts (1).
  6. Remove the water pump inlet from the water pump.
  7. Remove and discard the water pump inlet seal.
scientia non olet · About LEMON Manuals