Engine Coolant Fan Resistor Replacement (Right HP2)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Engine Coolant Fan Resistor (Right-HP2)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove air cleaner. Refer to Air Cleaner Assembly Replacement Disconnect the electrical connector from the resistor.
1	Engine Coolant Fan Resistor Bolt CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Engine Coolant Fan Resistor

Callout

Component Name

Preliminary Procedures

Engine Coolant Fan Resistor Bolt

CAUTION:

Tighten
10 N.m (89 lb in)

Engine Coolant Fan Resistor