LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Cooling System) >> Repair Instructions >> Engine Coolant Air Bleed Pipe Replacement (with AFM) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Coolant Air Bleed Pipe Seal
    GM1552485Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Position the O-ring seal (308) onto the nipple portion of the pipe.

  1. Install the seals onto the coolant air bleed pipe and/or covers.
    2. Fig 2: Engine Coolant Air Bleed Pipe
    GM1401993Courtesy of GENERAL MOTORS COMPANY
  2. Install the coolant air bleed pipe (307) and seals (308) onto the cylinder heads.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the coolant air bleed pipe bolts (309) and tighten to 12 N.m (106 lb in).
    4. Fig 3: Engine Coolant Air Bleed Cover Bolts
    GM1402001Courtesy of GENERAL MOTORS COMPANY
  4. Install the coolant air bleed covers (313) and seals (308), if required.
  5. If required, install the coolant air bleed cover bolts (312) 12 N.m (106 lb in).
    6. Fig 4: View Of Radiator Vent Inlet Hose & Clamps
    GM1699347Courtesy of GENERAL MOTORS COMPANY
  6. Install the radiator vent inlet hose (2) to the coolant air bleed pipe fitting.
  7. Position the radiator vent inlet hose clamp (1) at the coolant air bleed pipe fitting.
  8. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  9. Fill the cooling system. Refer to Cooling System Draining and Filling (Static Fill) .
  10. If the rear coolant air bleed covers were replaced, install the intake manifold. Refer to Intake Manifold Replacement (RPOs LC9, LMG, LY5, L76) , Intake Manifold Replacement (RPOs LY2, LY6) , Intake Manifold Replacement (Except RPOs LY2, LY6, LC9, LMG, LY5) .
scientia non olet · About LEMON Manuals