Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Cooling Fan Shroud & Bolts

Courtesy of GENERAL MOTORS COMPANY

NOTE:

Insert the 3 lower tabs into the radiator support flange. Keeping the shroud parallel to the radiator will ensure the correct installation of the lower tabs.

Install the cooling fan and shroud.

CAUTION:

Refer to Fastener Caution .

Install the cooling fan shroud bolts.
Tighten

Tighten the bolts to 9 N.m (80 lb in).

Fig 2: Engine Oil Cooler Quick Connect Fittings

Courtesy of GENERAL MOTORS COMPANY

If equipped, install the cooler lines to the clip and close the clip.

Fig 3: Cooling Fan Electrical Connectors

Courtesy of GENERAL MOTORS COMPANY

Connect the electrical connectors to the cooling fans.
Install the clip attaching the wiring harness to the shroud.
Install the transmission cooling line bolts to fan shroud.
Tighten

Tighten the bolts to 4 N.m (35 lb in).

Fig 4: View Of Surge Tank Inlet Hose & Clamps

Courtesy of GENERAL MOTORS COMPANY

If necessary, install the surge tank inlet hose to the radiator.
If necessary, reposition the surge tank inlet hose clamp at the radiator.

Fig 5: Radiator, Inlet & Outlet Hose & Clamps

Courtesy of GENERAL MOTORS COMPANY

Engage the radiator inlet hose clip (2) at the fan shroud.
Connect upper radiator hose from radiator.
Install air inlet duct.
Fill the cooling system. Refer to Cooling System Draining and Filling (Static Fill)