LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Cooling System) >> Repair Instructions >> Coolant Heater Cord Replacement (With LY2, LY5 or LMG) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Pan Skid Plate & Bolts
    GM1698082Courtesy of GENERAL MOTORS COMPANY
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the oil pan skid plate bolts and plate, if equipped.
    3. Fig 2: View Of Coolant Heater Cord
    GM1699548Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the coolant heater cord electrical connector.
    4. Fig 3: View Of Coolant Heater Cord & Components
    GM1702203Courtesy of GENERAL MOTORS COMPANY
  4. Remove the coolant heater cord retainer (5) from the frame.
  5. Remove the coolant heater cord clip (6) from the front brake front pipe.
  6. Lower the vehicle.
  7. Remove the coolant heater cord bolt (4) from the frame.
  8. Remove the coolant heater cord clip (2) from the chassis harness.
  9. Remove the coolant heater cord clip (1) from the front spring stud.
  10. Remove the coolant heater cord from the vehicle.
scientia non olet · About LEMON Manuals