LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Engine Block Valley Cover Installation

Engine Block Valley Cover Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Valley Cover & Gasket
    GM1403316Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    All gasket surfaces should be free of oil or other foreign material during assembly.

  1. Lubricate the O-ring seals with clean engine oil.
  2. Install the O-ring seals (537) to the cover (555).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the cover (555), gasket (556), and bolts (506). Tighten the manifold bolts to 25 N.m (18 lb ft).
    4. Fig 2: View Of Oil Pressure Sensor & Washer
    GM1403317Courtesy of GENERAL MOTORS COMPANY
  4. Apply sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent, to the threads of the sensor.
  5. Install the oil pressure sensor (706) and sealing washer (707). Tighten the sensor to 35 N.m (26 lb ft).
scientia non olet · About LEMON Manuals