LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - DTC P0010 To DTC P0430) >> Diagnostic Information and Procedures >> DTC P0230 (FPCM) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the K27 FPCM.
  2. Connect a test lamp between the control circuit terminal 13 and ground.
  3. Ignition ON, command the fuel pump ON and OFF with a scan tool. The test lamp should turn ON and OFF with each command.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K20 engine control module.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K20 engine control module.
  4. If all circuits test normal, replace the K27 FPCM.
scientia non olet · About LEMON Manuals