Conditions for Running the DTC

P0133 or P0153

• DTC P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135 or P2176 is not set.
• The ignition voltage is between 10-32 V.
• The engine coolant temperature (ECT) is warmer than 50°C (122°F).
• The intake air temperature (IAT) is warmer than -40°C (-40°F).
• The fuel level is greater than 10 percent.
• The engine run time is greater than 120 s.
• The engine speed is between 1,200-3,000 RPM.
• The barometric (BARO) pressure is greater than 70 kPa.
• The mass airflow (MAF) is between 20-55 g/s.
• The fuel system is in Closed Loop.
• Ethanol content is less than 87 percent.
• The fuel control state is not in power enrichment.
• Decel fuel cut off is not active.
• The DTCs run once per drive cycle when the above conditions are met for greater than 3.5 s.

P013A P013C, P013E, P014A, P015A, or P015C

• Before the ECM can report DTC P013E, or P014A failed, DTCs P2270 and P2272 must run and pass.
• Before the ECM can report DTC P013A, or P013C failed, DTCs P013E, P014A, P2270, and P2272 must run and pass.
• DTC P0030, P0036, P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0120, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0455, P0496, P1174, P1175, P1516, P2101, P2119, P2135, P2176, P2270, P2271 or P2A00 is not set.
• The ignition voltage is between 10-32 V.
• The fuel level is greater than 10 percent.
• The accelerator pedal (APP) is steady.
• Decel fuel cut-off is continued without driver input after the above conditions are met.
• The DTCs run once per ignition cycle, during decel fuel cut-off (DFCO), when the above conditions are met.

P013B P013D, P013F, P014B, P015B or P015D

• Before the ECM can report DTC P013F, or P014B failed, DTCs P2271, P2273, P013A, P013C, P013E, P014A, P2270, and P2272 and must run and pass.
• Before the ECM can report DTC P013B or P013D failed, DTCs P013F, P014B, P2271, P2273, P013A, P013C, P013E, P014A, P2270, and P2272 and must run and pass.
• DTC P0030, P0036, P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0120, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0455, P0496, P1174, P1175, P1516, P2101, P2119, P2135, P2176, P2270, P2271 or P2A00 is not set.
• The ignition voltage is between 10-32 V.
• The fuel level is greater than 10 percent.
• Fuel enrich mode continues after the above conditions are met.
• The DTCs run once per ignition cycle when the above conditions are met.