LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - DTC P0010 To DTC P0430) >> Diagnostic Information and Procedures >> DTC P0119 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Observe the scan tool engine coolant temperature (ECT) sensor parameter, while moving the ECT sensor connector and the K20 engine control module connector. The ECT sensor parameter should not fluctuate while moving the related harnesses and connectors.
    • Repair the suspected harness or connection if the ECT parameter fluctuates greater than 3°C (5°F) while moving the related harnesses and connectors.
  2. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals