Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON.
- Verify the scan tool ECT Sensor parameter is between -39 to + 120°C (-38 to +248°F) and changes with engine run time.
- If not between -39 to + 120°C (-38 to +248°F) or does not change
Refer to Circuit/System Testing .
- If between -39 to + 120°C (-38 to +248°F) and changes
- If not between -39 to + 120°C (-38 to +248°F) or does not change
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing .
- If the DTC does not set
- If the DTC sets
- All OK.