Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Verify that DTC P0641, or P0651 is not set.
- If the DTC is set
  Refer to DTC P0641 or P0651 (ECM) for further diagnosis.
- If the DTC is not set
Engine Idling.
Verify the scan tool MAP voltage parameter is between 0.3-4.8 V and changes with accelerator pedal input.
- If not between 0.3-4.8 V or does not change
  Refer to Circuit/System Testing - step 1 .
- If between 0.3-4.8 V and changes
Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed in the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing - step 1 .
- If the DTC does not set
All OK.