LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - DTC P0010 To DTC P0430) >> Diagnostic Information and Procedures >> DTC P0030, P0036, P0050, P0053, P0054, P0056, P0059, P0060, P0135, P0141, P0155, or P0161 >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different variant/trim than selected.

P0030, P0036, P0050, or P0056 

The ECM detects that the commanded state of the driver and the actual state of the control circuit do not match for greater than 5 seconds.

P0053, P0054, P0059, or P0060 

The ECM detects the HO2S heater is not within a specified resistance range at engine start-up for greater than 1 second.

P0135 or P0155 

The ECM detects that the HO2S 1 heater current is greater than 3.1 amps, or less than 0.3 amp for greater than 8 seconds.

P0141 or P0161 

The ECM detects that the HO2S 2 heater current is greater than 2.9 amps, or less than 0.3 amp for greater than 8 seconds.

scientia non olet · About LEMON Manuals