LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - DTC P0010 To DTC P0430) >> Diagnostic Information and Procedures >> DTC P0016 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON.
  2. Verify DTC P0335, P0336, P0340, P0341, P0641, or P0651 is not set.
    • If none of the DTCs are set 
  3. Engine running at normal operating temperature.
  4. Verify DTC P0016 is not set.
    • If the DTC is set 

      Inspect for the following and repair as necessary:

    • A camshaft position actuator solenoid valve that is stuck in the full advance or retard position (if equipped)
    • The correct installation of the camshaft position actuator solenoid valve (if equipped)
    • The correct installation of the camshaft sensor
    • The correct installation of the crankshaft sensor
    • A timing chain tensioner condition
    • An incorrectly installed timing chain
    • Excessive play in the timing chain or sprockets
    • A timing chain that jumped teeth
    • If the DTC is not set 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  6. Verify the DTC is not set.
    • If the DTC is set 

      A mechanical condition listed above still exists.

    • If the DTC is not set 
  7. All OK.
scientia non olet · About LEMON Manuals