LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - DTC P0010 To DTC P0430) >> Diagnostic Information and Procedures >> DTC P0011 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.

Static Test

  1. Ignition OFF, remove the camshaft position actuator magnet.
  2. Test for 5.0-9.0 Ω between the solenoid control terminal 2 and the low reference terminal 1 at the camshaft position actuator magnet.
    • If not within the specified range, replace the camshaft position actuator magnet.
  3. Test for infinite resistance between each terminal of the magnet and the magnet housing.
    • If not the specified value, replace the camshaft position actuator magnet.
    • If within the specified value go to 4.
  4. All OK.

Dynamic Test

  1. Remove the camshaft position actuator magnet.
    2. NOTE:
    • The camshaft position actuator magnet pintle should be facing downward for this test.
    • Do not allow electrical current to flow through the camshaft position actuator magnet for greater than 1-2 s.
  2. Install a 20 A fused jumper wire between the control circuit terminal 2 and 12 V. Momentarily install a jumper wire between the low reference terminal 1 and ground. The pintle should extent.
    • If the function does not perform as specified, replace the camshaft position actuator magnet.
scientia non olet · About LEMON Manuals