LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - DTC P0010 To DTC P0430) >> Diagnostic Information and Procedures >> DTC P0010, P0013, or P2088-P2095 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
    NOTE:

    If a crankshaft or camshaft position sensor DTC is set, the CMP Actuator output control will not function.

  1. Ignition ON, observe the DTC information with a scan tool. Verify DTC P0335, P0336, P0340, or P0341 is not set.
  2. Verify the CMP Sol Ckt Test Status parameters listed below display OK or Not Run:
    • CMP Sol Ckt Open Test Status
    • CMP Sol Ckt Short To Grd Test Status
    • CMP Sol Ckt Short Volts Test Status
  3. Engine idling, verify the CMP Sol Ckt Test Status parameters listed below display OK or Not Run:
    • CMP Sol Ckt Open Test Status
    • CMP Sol Ckt Short To Grd Test Status
    • CMP Sol Ckt Short Volts Test Status
  4. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals