Symptoms Verification

Before using the Symptom tables, perform the following inspections:

• Verify the engine control module (ECM) and malfunction indicator lamp (MIL) are operating correctly.
• Verify there are no DTCs that are stored.
• Verify the scan tool data is within a normal operating range.
• Verify the customer concern.
• Perform the Visual/Physical Inspection in this section. The visual/physical inspection is extremely important, and can lead to correcting a condition without additional testing. It may also help reveal the cause of an intermittent condition.

Identifying Intermittent Conditions 

Many intermittent conditions occur with harness or connector movement due to engine torque, rough pavement, vibration or physical movements of a component. Refer to the following for a list of issues that may cause an intermittent condition:

• Moisture and water intrusion in connectors, terminals, and components
• Incomplete connector mating
• Poor terminal contact
• High circuit or component resistance-High resistance can include any resistance, regardless of the amount, which can interrupt the operation of the component.
• Harness that is too short or tight
• Wire insulation that is chaffed or cut
• High or low ambient temperature
• High or low engine coolant temperatures
• High underhood temperatures
• Heat build up in component or circuit due to circuit resistance, poor terminal contact, or high electrical load
• High or low system voltage
• High vehicle load conditions
• Rough road surfaces
• Electro-magnetic interference (EMI)/circuit interference from relays, solenoids or other electrical surge
• Incorrect installation of aftermarket, add on accessories

Visual/Physical Check

• Verify the control module grounds are clean, tight, and correctly located.
• Verify the vacuum hoses are not split or kinked, and are properly connected, as shown on the Vehicle Emission Control Information label.
• Verify the air filter is clean and free from restrictions.
• Verify there is no water intrusion in connectors terminals and components.
• Inspect the air intake ducts for the following conditions:
  • Collapsed
  • Damaged areas
  • Looseness
  • Incorrect installation
  • Leaking
• Inspect for air leaks at the throttle body mounting area, the mass air flow (MAF) sensor and intake manifold sealing surfaces.
• Inspect the wiring harness for the following conditions:
  • Poor connections
  • Pinches
  • Cuts
• Inspect for loose, damaged, unseated, or missing sensors/components.
• Inspect the terminals for corrosion and correct contact.