LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - DTC P0442 To DTC P3449 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P2632 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
NOTE:

An open or a short to voltage in the control circuit will cause both the Ckt. Open Test Status and the Ckt. Short Volts Test Status parameters to display Fault.

  1. Ignition ON, command the Fuel Pump 2 Relay ON and OFF with a scan tool while observing the following control circuit status parameters:
    • Fuel Pump 2 Relay Ckt. Short Gnd Test Status
    • Fuel Pump 2 Relay Ckt. Open Test Status
    • Fuel Pump 2 Relay Ckt. Short Volts Test Status

      Each parameter should toggle between OK and Not Run or Not Run and OK.

  2. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals