LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - DTC P0442 To DTC P3449 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0446 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON and fuel cap removed, verify the scan tool FTP sensor parameter is between 1.3-1.7 V.
  2. Install the fuel cap.
  3. Engine running, the EVAP vent solenoid valve open, command the EVAP purge solenoid valve to 100 % with a scan tool. The reading should not increase to greater than -15 mm Hg (-8 in H2O).
  4. Using the scan tool, decrease the canister purge duty cycle from 100 % to 0 %. The vacuum should decrease to near zero.
    • If the fuel tank vacuum does not return to zero or appears to decrease too slowly go to the restriction section in Circuit/System Testing .
  5. Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
scientia non olet · About LEMON Manuals