LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - DTC P0442 To DTC P3449 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0443 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON, engine OFF, you should hear the solenoid clicking when the EVAP purge solenoid is command to 50 % with a scan tool.
  2. Verify the control circuit parameter status while commanding the EVAP purge solenoid from 0 to 50 % and back to 0 % with a scan tool.
    • EVAP Purge Solenoid Valve Control Circuit High Voltage Test Status
    • EVAP Purge Solenoid Valve Control Circuit Low Voltage Test Status
    • EVAP Purge Solenoid Valve Control Circuit Open Test Status

      Each parameter should display OK or Not Run.

  3. Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
scientia non olet · About LEMON Manuals