Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P010C, P010D, P0101, P0102, P0103, P0106, P0107, P0108, P0111, P0112, P0113, P0114, P0116, P0117, P0118, P0125, P0128, P0443, P0446, P0449, P0452, P0453, P0455, P0496, P0502, P0503, P0722, P0723, P2610, P2227, P2228, P2229 P2230 are not set.
The barometric pressure (BARO) is greater than 70 kPa.
No fuel filling during the EONV test period.
The fuel level is between 10-90 %.
The cold start-up engine coolant temperature (ECT) and the start-up intake air temperature (IAT) are within 8°C (46°F).
The engine coolant temperature (ECT) is greater than 63°C (145°F).
The engine run time before engine shut-off was greater than 10 min.
The drive distance before engine shut-off was greater than 5 kilometers (3.1 miles).
The ignition is OFF.
The ambient air temperature at the end of the drive cycle is between 0-34°C (32-93°F).
DTC P0442 runs once per drive cycle during the hot soak period after the ignition is turned OFF and may require up to 45 min to complete. The controller will not make more than 2 test attempts per day. The time since the last completed EONV test must be at least 17 h if passed or 10 h if failed.