Installation Procedure

Fig 1: Power Brake Booster Nuts (With JF4)

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

NOTE:

Tighten the upper right hand nut first.

Fig 2: Identifying Brake Booster Pushrod Retainer (With JF4)

Courtesy of GENERAL MOTORS COMPANY

Fig 3: Identifying Brake Booster Pushrod Retainer Bolt (With JF4)

Courtesy of GENERAL MOTORS COMPANY

Install the brake booster pushrod retainer bolt (1) and tighten to 10 N.m (89 lb in).

Fig 4: Power Brake Booster Fluid Outlet Pipe Fitting (Without JF4)

Courtesy of GENERAL MOTORS COMPANY

Install the power brake booster hose outlet pipe fitting (1) and tighten to 33 N.m (24 lb ft).

Fig 5: Power Brake Booster Fluid Inlet Pipe Fitting (Without JF4)

Courtesy of GENERAL MOTORS COMPANY

Install the power brake booster hose inlet pipe fitting (1) and tighten to 33 N.m (24 lb ft).

Fig 6: Power Brake Booster Fluid Return Hose (Without JF4)

Courtesy of GENERAL MOTORS COMPANY

Install the power brake booster fluid return hose (1) and secure the clamp.
Install the brake master cylinder. Refer to Master Cylinder Replacement (JD9) , Master Cylinder Replacement (JH6) , Master Cylinder Replacement (Two-mode Hybrid) .
Bleed the power steering system. Refer to Power Steering System Bleeding .
Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .