Front Brake Hose Replacement (JD9)

Fig 1: View Of Front Brake Hose Components (JD9)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to Brake Dust Warning . WARNING: Refer to Brake Fluid Irritant Warning . Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (6-Lug Wheel) , Tire and Wheel Removal and Installation (8-Lug Wheel) .
1	Wheel Speed Sensor Wire Clip
2	Hose Bracket to Control Arm Bolt CAUTION: Refer to Fastener Caution . Tighten 9 N.m (80 lb in)
3	Wheel Speed Sensor Wire Clip
4	Brake Pipe Fitting Procedure Remove any dirt or debris from the brake pipe fitting. Cap the brake pipe fitting to prevent brake fluid loss and contamination. Tighten 25 N.m (18 lb ft)
5	Hose Bracket to Frame Bolt Tighten 12 N.m (106 lb in)
6	Brake Hose Fitting Bolt Tighten 40 N.m (30 lb ft)
7	Brake Hose Fitting Gasket (Qty: 2) Procedure Discard the brake hose fitting gaskets. Install 2 new brake hose fitting gaskets.
8	Brake Hose Procedure Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Pressure) , Hydraulic Brake System Bleeding (Two-mode Hybrid) , Hydraulic Brake System Bleeding (Manual) .