Installation Procedure

Fig 1: Brake Pedal

Courtesy of GENERAL MOTORS COMPANY

Fig 2: Brake Pedal Pivot Bolt

Courtesy of GENERAL MOTORS COMPANY

If installing a new brake pedal pivot bushing, ensure the conical flange end of the bushing is on the inboard side of the pedal.
For installation, apply high temperature grease GM P/N 12345996 (Canadian P/N 10953501) to the ID of the brake pedal pivot bushing.
Install the brake pedal pivot bolt (1).

Fig 3: Brake Pedal Pivot Nut

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

While holding the brake pedal pivot bolt stationary, install the brake pedal pivot nut (1) and tighten to 26 N.m (19 lb ft).
Apply a thin coat of high temperature lubricant, GM P/N 12345996 (Canadian P/N 10953501) to the brake pedal pivot pin.
Connect the power brake booster pushrod.

Fig 4: Power Brake Booster Pushrod Retaining Clip

Courtesy of GENERAL MOTORS COMPANY

Install the power brake booster pushrod retaining clip (1).
Rotate the power brake booster retaining clip 360 degrees to ensure the clip is fully engaged in the brake pedal pivot pin groove.

Fig 5: Power Brake Booster Pushrod Retaining Clip Bolt

Courtesy of GENERAL MOTORS COMPANY

Install the power brake booster pushrod retaining clip bolt (1) and tighten to 10 N.m (89 lb in).

Fig 6: Brake Pedal Position Sensor

Courtesy of GENERAL MOTORS COMPANY

Fig 7: Brake Pedal Position Sensor Bolt

Courtesy of GENERAL MOTORS COMPANY

Install the brake pedal position sensor bolt (1).
Connect the brake pedal position sensor electrical connector.
Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .