LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Brake Master Cylinder Reservoir Hose Replacement >> Installation Procedure

Installation Procedure

    Fig 1: BPMV Return Hose Quick Connect
    GM1965632Courtesy of GENERAL MOTORS COMPANY
  1. Install the supply and return hoses to the vehicle and the retainers.
  2. Connect the BPMV return hose quick connect (1).

    Ensure the return hose quick connect is fully engaged by attempting to pull the return hose from the outlet fitting.

    3. Fig 2: BPMV Supply Hose Quick Connect
    GM1965631Courtesy of GENERAL MOTORS COMPANY
  3. Connect the BPMV supply hose quick connect (1).

    Ensure the supply hose quick connect is fully engaged by attempting to pull the supply hose from the inlet fitting.

    4. Fig 3: ABS Module Splash Shield
    GM1965627Courtesy of GENERAL MOTORS COMPANY
  4. Install the ABS module splash shield (1).
    5. CAUTION:

    Refer to Fastener Caution .

    Fig 4: ABS Module Splash Shield Bolts
    GM1965625Courtesy of GENERAL MOTORS COMPANY
  5. Install the ABS module splash shield bolts (1) and tighten to 20 N.m (15 lb ft).
    6. Fig 5: ABS Module Splash Shield Retainers
    GM1965624Courtesy of GENERAL MOTORS COMPANY
  6. Install the ABS module splash shield retainers (1).
  7. Lower the vehicle.
    8. Fig 6: View Of Brake Master Cylinder Reservoir Return Hose Quick Connect & Supply Hose Quick Connect
    GM1892190Courtesy of GENERAL MOTORS COMPANY
  8. Connect the brake master cylinder reservoir return hose quick connect (1).
  9. Connect the brake master cylinder reservoir supply hose quick connect (2).
  10. Fill the brake master cylinder reservoir. Refer to Master Cylinder Reservoir Filling .
scientia non olet · About LEMON Manuals