Rear Seat Removal and Installation (Avalanche/Escalade EXT)

Fig 1: View Of Rear Seat Assembly, Nuts & Rear Seat Belt Buckle Anchor Nut

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the jack access cover and jack from the vehicle. Remove the rear seat track finish cover.
1	Rear Seat Assembly Nut (Qty: 7) CAUTION: Refer to Fastener Caution . TIP: Remove the adjuster cover to access the nuts. Tighten 45 N.m (33 lb ft)
2	Rear Seat Belt Buckle Anchor Nut TIP: The nut is located behind the seat. Tighten 45 N.m (33 lb ft)
3	Rear Seat Assembly Procedure Disconnect the electrical connector, if equipped.