LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - On Vehicle >> Transfer Case Rear Extension Bushing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Output Shaft Bushing
    GM1549538Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Install the bushing with the notched area facing outward and properly aligned to the rear case. Oil pick up "slot" should be straight down in the vehicle.

  1. Using J-45380  transfer case rear bushing remover and installer install the output shaft bushing, if removed or new.
  2. Install the rear output shaft seal. Refer to Rear Output Shaft Seal Replacement .
scientia non olet · About LEMON Manuals