LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 2ML70 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Auxiliary Fluid Pump and Gasket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Auxiliary Fluid Pump Wire Harness, Control Module Connector, Wire Harness, Retainers & Clip Nut
    GM1975037Courtesy of GENERAL MOTORS COMPANY
  1. Disconnect the auxiliary fluid pump wire harness (1) from the auxiliary fluid pump control module connector (2).
  2. Remove the auxiliary fluid pump wire harness (6) from the harness retainers (7).
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the auxiliary fluid pump wire harness clip nut (3).
  5. Place a suitable drain pan under the transmission auxiliary fluid pump.
    6. Fig 2: Auxiliary Fluid Pump Gasket, Pump & Bolts
    GM1975016Courtesy of GENERAL MOTORS COMPANY
  6. Remove the auxiliary fluid pump bolts (1).
    7. CAUTION:

    Do not damage the case sealing surface when removing or installing the pump and motor assembly.

  7. Remove the auxiliary fluid pump (2).
    8. CAUTION:

    The auxiliary fluid pump gasket is not re-usable. Use a NEW gasket when replacing or damage may occur.

  8. Remove the auxiliary fluid pump gasket (3).
scientia non olet · About LEMON Manuals