LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 2ML70 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Range Selector Lever & Nut
    GM1970155Courtesy of GENERAL MOTORS COMPANY
  1. Install the range selector lever (2).
    2. WARNING:

    Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.

    CAUTION:

    Refer to Fastener Caution .

  2. Install the range selector lever nut (1) and tighten to 25 N.m (18 lb ft).
    3. Fig 2: Range Selector Lever Cable & Retainer
    GM1970184Courtesy of GENERAL MOTORS COMPANY
  3. Install the range selector lever cable (2) to the cable bracket.
  4. Install the range selector lever cable retainer (1).
  5. Connect the range selector lever cable (2) to the range select lever.
    6. Fig 3: Range Selector Lever Cable Heat Shield & Bolts
    GM1970183Courtesy of GENERAL MOTORS COMPANY
  6. Install the range selector lever cable heat shield (2).
  7. Install the range selector lever cable heat shield bolts (1) and tighten to 17 N.m (13 lb ft).
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals