LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Hybrid/EV Control System) >> Diagnostic Information and Procedures >> DTC P1B0D or P1B0E >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Verify that DTC P0723 is not set.
  2. Verify there is no other hybrid Transmission DTCs set.
  3. Ignition OFF for at least one minute. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. Verify that DTCs P1B0D or P1B0E is not set.
  4. If DTCs P1B0D or P1B0E is set, program the drive motor generator power inverter module with the latest software version. If the DTC resets replace the T6 drive motor generator power inverter module.