Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P1B05 and P1B06
- The ignition voltage is 8-18 V.
- Wake up signal is active.
- Battery energy control module is supplying current on the high voltage interlock circuit. This normally occurs when high voltage contactor relays are closed.
P1AE2, P1AE3 and P1AE4
- The ignition voltage is 9-18 V.
- Wake up signal is active.
- Battery energy control module is supplying current on the high voltage interlock circuit. This normally occurs when high voltage contactor relays are closed.